Rhesus monkey (Simian)
Samples to be analyzed
Tissue homogenates, cell lysates and other biological fluids.
Please refer to Uniprot
Cytochrome P450 1A1
Alternate gene name
CYP1; AHH; AHRR; CP11; CYP1; P1-450; P450-C; P450DX; Cytochrome P450,Subfamily I(Aromatic Compound-Inducible),Polypeptide 1
This assay has high sensitivity and excellent specificity for detection of Cytochrome P450 1A1 (CYP1A1). No significant cross-reactivity or interference between Cytochrome P450 1A1 (CYP1A1) and analogues was observed.
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Cytochrome P450 1A1 (CYP1A1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Cytochrome P450 1A1 (CYP1A1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Cytochrome P450 1A1 (CYP1A1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Cytochrome P450 1A1 (CYP1A1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
Precision of the test
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Cytochrome P450 1A1 (CYP1A1) were tested 20 times on one plate, respectively. Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Cytochrome P450 1A1 (CYP1A1) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100 Intra-Assay: CV
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
The Kit is manufactured at ISO 9001 and ISO 13485 certified facilities.
Research main area